|Forums | USR | my modem..||Watch|
|Posted - 9/29/2001 11:54:02 AM |
my v.92 modem will only dial in at v.34 why..
|Posted - 9/29/2001 11:59:52 AM |
My car won't do but 40MPH, why?
That's not a whole lot to go on, is it?
|Posted - 9/29/2001 9:48:30 PM |
Have you ever gotten a 56k speed on this pc/line/ISP? If you did, and now don't with this USR, and there are no "extra settings", take it back. If this is your first attempt with pc/line/ISP, your line may not be 56k compatible.
|Posted - 9/30/2001 5:06:01 AM |
Here is my modem log
09-30-2001 07:51:02.30 - Sportster V.90 56K Faxmodem in use.
|Posted - 9/30/2001 8:46:38 AM |
Must be a Plymouth Horizon hehehe :D
|Posted - 9/30/2001 10:02:47 AM |
Remove extra init string settings.
Check to make sure modem is installed with correct .inf file (driver); Your log indicates modem is getting AT&F; 56k USR modems should get AT&F1.
I would suggest making test call in Hyperterminal using AT&F1, then dialing.
Also, check y11 results to see if your line is 56k-capable
|Posted - 9/30/2001 10:35:41 AM |
This is my aty11 result doesn't look too good ... ;(
It's strange because when I dialed in at compuserve I made v.90 connections, I recently changed to Bellsouth and this problem began then..
Freq Level (dB)
|Posted - 10/2/2001 10:12:16 PM |
As Richard stated you should install the modem with the correct drivers, may help improve performance a little.
Since you've switched ISPs you're connecting to different equipment and the call is routed differently. This could also be contributing to your slow connections.
Install the correct drivers and then post another modem log and the ati6i11 data, perhaps someone might see where the problem is.
Click Here To Close Thread, Administrators & Moderators Only.
Show All Forums |