Modemsite's Forum56 - The Modem Board
Main | profile | register | search | help | Ad-free Login
Forums | USR (Public) | Ext Sportster 56000 Fax -- superslow    Watch  
Author Topic
p0gue
Tl Posts:
2

USA
Posted - 5/15/2005 4:59:31 PM  Show Profile  Email Poster  Edit Message
Im only connecting at 24k. Any ideas? U.S. Robotics Sportster 56000 Fax Link Diagnostics... Chars sent 33239 Chars Received 116480 Chars lost 0 Octets sent 21826 Octets Received 89111 Blocks sent 699 Blocks Received 836 Blocks resent 25 Retrains Requested 0 Retrains Granted 0 Line Reversals 0 Blers 1 Link Timeouts 0 Link Naks 6 Data Compression V42BIS 2048/32 Equalization Long Fallback Enabled Protocol LAPM/SREJ Speed 28800/28800 Last Call 00:04:01 Disconnect Reason is DTR dropped U.S. Robotics Sportster 56000 Fax Link Diagnostics... Modulation V.34 Carrier Freq (Hz) 1829/1920 Symbol Rate 3200/3200 Trellis Code 64S-4D/64S-4D Nonlinear Encoding ON/ON Precoding ON/ON Shaping OFF/ON Preemphasis (-dB) 7/10 Recv/Xmit Level (-dBm) 25/9 Near Echo Loss (dB) 21 Far Echo Loss (dB) 55 Carrier Offset (Hz) 7880 Round Trip Delay (msec) 16 Timing Offset (ppm) 10480 SNR (dB) 37 Status : 0000,0001,0100,1011,1000,1000,1000,1101 Freq Level (dB) 150 25 300 24 450 24 600 24 750 23 900 23 1050 23 1200 24 1350 24 1500 24 1650 24 1800 24 1950 24 2100 24 2250 24 2400 25 2550 25 2700 26 2850 26 3000 26 3150 27 3300 32 3450 38 3600 45 3750 54 OK

v.Richard
Tl Posts:
6222

USA
Posted - 5/15/2005 11:43:42 PM  Show Profile  Email Poster  Edit Message  v.Richards Homepage
Poor/marginal phone line -
www.modemsite.com/56k/x2-adconversion.asp

I would suggest doing the direct to demarc procedure and checking diagnostic results there as well. If your 3750 value stays at 54 and the 3300 stays at 32 for the aty11, your connect speed may not get any better; however, the retrains requested is very high, so you might find some relief with the procedure; or, you might get telco to check your line if the demarc test yields no benefit:
www.modemsite.com/56k/demarc.asp

Aloha! Richard.

Click Here To Close Thread, Administrators & Moderators Only.

Show All Forums |