Modemsite's Forum56 - The Modem Board
Main | profile | register | search | help | Ad-free Login
Forums | Agere (Public) | caller id    Watch  
Author Topic
ordenzo74
Tl Posts:
1

Fed Rep Yugoslavia
Posted - 9/23/2005 7:21:52 AM  Show Profile  Email Poster  Edit Message
Can somebody tell me how to enable my Agere Systems AC'97 modem to enable caller ID? I recently installed that progam but i van't enable it via the modem
Thanks
v.Richard
Tl Posts:
6222

USA
Posted - 9/25/2005 4:10:18 PM  Show Profile  Email Poster  Edit Message  v.Richards Homepage
What program did you recently install?

All Agere AC'97 modems should support caller id;
requires setting your country code to correct country- caller id signalling can vary from country to country - it is possible that Yugoslavia is not supported. As far as I can tell, Yugoslavia itself does not have country code for Agere modems (uses same as LTWin - see - www.modemsite.com/56k/ltwin9.asp )
so, if that is the case, you need to determine whether the signalling matches any other country that is listed, and set the country code appropriate with
AT%T19,0,## where ## is country code.

What type of caller id are you asking about?
Type 1 - when the modem is not in use, or type 2/callwaiting caller id?

To verify whether caller id is supported/detected for type 1, you can use Hyperterminal connected directly to modem COM port as described at
www.modemsite.com/56k/x2-hyperterm.asp

Then, issue the command:
AT+VCID=1
which should return OK.
Then, have someone call your line.
The callerid info should display in the Hyperterminal window after RING...

Aloha! Richard.

Click Here To Close Thread, Administrators & Moderators Only.

Show All Forums |